Shifter Boot Trim Plate

Shifter Boot Trim PlateThis Shifter Boot Trim Plate is designed to add that custom look to the interior of your car, while being incredibly easy to install and easy to remove if you ever need access to that area. This Trim Plate is CNC machined from 6061 Aluminum, and there's even an option to get a black powder coated trim piece if you're going for that stealth look. This Trim Plate is designed to fit the fairly common 5. 5" x 6. 5" rubber shifter boot, but if you don't

breathable fabric shirt

This Trim Plate is designed to fit the fairly common 5

Remove the bracket and drill the single hole with a 5/16" drill bit

Finally a KruseBuilt Hat

This Brace kit is designed to eliminate the flexing of the firewall under hard braking scenarios

powder coated in Satin Black for a long-lasting

It connects the factory brake installed along the F100 frame rail to the brake lines attached to the S550 rear calipers

If you'd like a set of four caps for your vehicle

The Monte Carlo Bar:  A structural brace that connects the left and right shock towers across the engine bay to reduce the tendency of the shock towers to move toward or away from each other when the car is under load

The included relay is designed to power a single fan while still allowing manual override via the switch

com/products/brake-master-cylinder-brace-1964-1966-mustang

The fine thread bolt must only be used to attach the rod end to the "z" bracket