Support Rail for 1.5" Linear Shafts - Aluminum SR24-036.000-SL Length 36"

Support Rail for 1.5" Linear Shafts - Aluminum SR24-036.000-SL Length 36"Linear support rail, undrilled, 36" in length and made for a 1. 5" diameter linear shaft, sold separately. A support rail is a linear rail on top of which shafts can handle heavy loads without sagging or binding. This solid aluminum rail, made in the USA with advanced cold stamp manufacturing, pairs with shafts on which run open shelled linear bearings or roller bearing pillow blocks. Support Rail Only Linear shafts sold separately Solid Undrilled;

Cold Stamp manufactured from aluminum in the PBC Linear factory in Roscoe

with a 25mm ID and double wide design for higher cantilevered load capacity

Outer Diameter: 18mm

Double Seals: Included as standard at no additional cost

corrosion-resistant sliding on a stainless steel square shaft

5" diameter precision case hardened and ground steel shaft

Round flanged plain linear bearing of 16mm ISO Metric ID (inner diameter) and part of the Simplicity® product line

Ceramic Coated Aluminum Linear Shaft with a 5/8" diameter and 12" length

0015” per side allows pairing with another bearing on a parallel shaft with imperfect alignment

Matches Hevi-Rail Linear Rail HVR-6 U-Type

round-end-flange w/ a 20mm precision ID

or high-temperature environments where ball bearings often fail